||24 h (total drying)
||Spatula or trowel.
||Interiors and exteriors under roof
|TECHNICAL DATA SHEET
Repairs superficial defects.
Fill plate joints.
Smooth rough surfaces.
It regulates great superficial defects.
Excellent texture and adhesion.
Easy application and good sanding.
High strength and durability.
Does not crack.
Suitable for interiors and exteriors.
Free of emissions VOCs and formaldehydes.
Apparent density: 1.5 ± 0.05 g/cm3 pH 12.5 ± 1 Solid content 72 ± 5 %
Appearance: Dense white paste
Yield: 600-700 g/m2 (1mm of thickness). It depends on the type and condition of the substrate. The exact consumption must be determined by the means of a sampling of the work.
Storage: Keep in original pack, closed and in a cool and dry place. Keep from freezing and avoid direct sun exposure. Unopened, it may be conserved for at least 36 months from the date of manufacture.
Application surfaces: It can be applied on all types of surfaces common in construction: mortar, concrete, plaster, prefabricated boards, etc.
Conditions of the substrate: The substrate must be dry, firm, well-adhered and free from any impurities that may hinder the product from setting fully. Preparation of the substrate: If the substrate presents algae, mould, fungi and / or other impurities, it is recommended to do a thorough cleaning, eliminating in its entirety and with specific products for this purpose. If the support has poor adhesion (gritty, dusty, etc.), brush and consolidate with Minerseal Premium diluted 3: 1 with water. If the substrate has salt deposits, brush and apply Neutralysal Premium.
Preparation of the product: Mix the product and gradually add water to 30-35% by weight of the product until a smooth and uniform texture is obtained.
Superficial defects: fill in the surface defect and/or union between plates. Place a 2 mm grid fiberglass mesh for joints and surface bricks greater than 1 mm. Finally, regularize the substrate by applying 1-2 layers and when dry sand it.
Smooth surfaces: apply 2-3 layer properly extending the product. After drying, sand and brush. Working thickness: <3 mm. Drying: In conditions of 25 ºC and 60% relative humidity: 24 hours between layers and for sanding.
Environmental conditions: The work temperature (environment and support) must be between +5 °C and +32 °C. Do not apply in direct sunlight or on substrate heated by the sun.
Tools: Spatula or trowel.
Tool cleaning: Clean tools after use with warm water.
Notes: The mineral substrate must be at least 28 days old. The substrates to be treated must be resistant to high alkalinity. Do not apply to surfaces in constant contact with water. In case of rain, let the substrate dry for at least 24 hours before applying. It is recommended to protect the treated surface from rain until painting. The parts that are not going to be treated must be protected (glass, wood, etc.). Do not mix with other products or specific properties may change.